Products sold by come with ’s 1-year, 2-year, or 3-year warranty and do not come with the original manufacturer’s warranty. is not an authorized distributor, affiliate, or representative for the brands we carry. PS: I have no inverter to test right know, maybe this is just normal behaviour when you have no port or inverters connected? ![]() Am I doing something wrong? I understand that start/stop commands can be activated by simply activating the correct bits of I/F Area, and same for frequency data. I notice that I/F Area registers, where you set frequency and start/stop commands, changes values sometimes, and ReadParameter blocks take a couple of seconds to execute. I got a word where I store the nº of inverter to read (1 to 3), I add 1 to this word everytime the secon ReadParameter block finishes, and goes back to 1 when needed. Then I use falling edge of this block to execute next ReadParameter. ![]() I use falling edge of refresh busy singal to execute first ReadParameter. My INV002_Refresh_X31 block is always on (P_On in EN input). ![]() I'm using two INV206_ReadParameter blocks to read frequency and current from inverters. I would use a carousel to feed the values into the blocks as needed. ![]() Adjust the interval of the refresh block so it won't interfere. Both blocks need to be on all the time, and like you said use the falling edge of the buys bit to trigger the parameter read.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |